■Connecting to a USB port

Follow the following procedures to connect

the PT-9500PC to the USB port of a personal computer running Windows® 98/98 SE/Me/ 2000 Pro/XP using the “Basic setup” (→ P.26) or to the USB port of a Macintosh.

Note

●The USB interface cable is connected to a personal computer running Windows while the software is being installed and is connected to a Macintosh after the software has been installed. Do not connect the PT-9500PC to a personal computer until instructed to do so.

Note

●When making a USB connection through a hub, a proper connection may not be possible due to the type of hub used. If this occurs, connect the PT-9500PC to a personal computer directly with the USB interface cable.

●The PT-9500PC cannot be connected to

the USB port of a personal computer running Windows® 95/NT 4.0. In this case, the PT-9500PC must be connected to the serial port.

1Preparecable. the included USB interface

Connect to PT-9500PC

Connect to personal

USB port.

computer USB port.

2Insert the plug on the end of the USB interface cable into the USB port on the back of the PT-9500PC.

Before use

3Insert the plug on the end of the USB interface cable into the USB port on the personal computer.

•The location of the USB port varies according to the personal computer. For details, refer to the instruction manual for the personal computer.

Note

●To use the PT-9500PC, the software must

be installed on the personal computer. Proceed to “Installing the software” (→ P.23).

17