Needle and embroidery foot section
aThread guide disk
Pass the thread through the thread guide disk when using the needle threader to thread the needle.
bNeedle bar thread guide
Pass the upper thread through the needle bar thread guide.
cNeedle plate
When the needle is lowered, it enters the hole in the needle plate.
dNeedle plate cover
Remove the needle plate cover to clean the bobbin case and race.
eBobbin cover/bobbin case
Remove the bobbin cover, and then insert the bobbin into the bobbin case.
fEmbroidery foot “Q”
This presser foot is used for embroidering.
Right-side/rear view
aHandle
Carry the machine by its handle when transporting the machine.
bHandwheel
Turn the handwheel toward you (counterclockwise) to raise and lower the needle.
cEmbroidery card slot Insert the embroidery card.
dAir vent
The air vent allows the air surrounding the motor to be exchanged. Do not cover the air vent while the machine is being used.
ePower supply jack
Insert the plug on the power supply cord into the power supply jack.
fMain power switch
Use the main power switch to turn the machine on and off.
Memo
zRefer to pages 8 through 11 while you are learning to use your machine.
9
