GETTING READY
Replacing the needle
Replace the needle as described below. Use the screwdriver and a needle that has been determined to be straight according to the instructions in “Checking the needle” (page 35).
aPress 
(Needle position button) once or twice to raise the needle.
1
aNeedle position button
bTurn off the machine.
CAUTION
●Before replacing the needle, be sure to turn off the machine, otherwise injuries
may occur if 
(Start/stop button) is accidentally pressed and the machine starts embroidering.
cLower the presser foot lever.
dPlace fabric or paper under the embroidery foot to cover the hole in the needle plate.
Note
zBefore replacing the needle, cover the hole in the needle plate with fabric or paper to prevent the needle from falling into the machine.
eHold the needle with your left hand, and then use a screwdriver to turn the needle clamp screw toward you (counterclockwise) to remove the needle.
1
2
aScrewdriver
bNeedle clamp screw
•Do not apply a strong force when loosening or tightening the needle clamp screw, otherwise certain parts of the machine may be damaged.
1
aPresser foot lever
36
