Adjusting the LCD
If nothing appears on the LCD when the machine is turned on, the brightness of the LCD is either too light or too dark. In such a case, perform the following operation.
aTurn off the machine.
bTurn on the machine while pressing any of the display panel buttons.
Operation beep
Each time a key is pressed you will hear one beep. If an incorrect operation is performed you will hear two or four beeps.
■If a key is pressed (correct operation) One beep sounds.
■If an incorrect operation is performed Two or four beeps sound.
■If the machine locks up, for example, because the thread is tangled
The machine beeps for four seconds and the machine automatically stops.
Be sure to check for the cause of the error, and | 3 |
correct it before continuing to embroider. |
|
cPress 
or 
.
dTurn off the machine, then turn it on again.
Troubleshooting 81
