Error Message | Probable Cause |
|
|
|
|
| This message is displayed when the embroidery unit is trying to |
|
| initialize while the embroidery foot is lowered. |
|
|
|
|
| The needle position button or thread cutter button was pressed while |
|
| the bobbin winder shaft is moved to the right. |
|
|
|
|
| A pattern is being stored. |
|
|
| 3 |
| The start/stop button was pressed when no pattern is selected. | |
|
|
|
| Bobbin thread has run out. |
|
| Little bobbin thread remains. |
|
|
|
|
| When the embroidery unit is attached, and then the machine is turned |
|
| on. |
|
|
|
|
| You tried to set a number of characters that will not fit within the frame. |
|
|
|
|
| The upper thread has become tangled around the bobbin case, and the |
|
| needle is bent and hitting the needle plate, etc., so the machine stops |
|
| (refer to page 74). |
|
|
|
|
| A card that cannot be used with this machine has been inserted, and |
|
| you tried to select a pattern from the card. |
|
|
|
|
| An embroidery card incompatible with this machine was inserted and a |
|
| pattern on the card was selected. |
|
|
|
|
| You try to retrieve a pattern downloaded as one for a different machine. |
|
|
|
|
| The combined character pattern is too large for the embroidery frame. |
|
| You can rotate the pattern 90 degrees and continue combining |
|
| characters. |
|
|
|
|
Troubleshooting 79