Brother CS 80 manual Remove the shuttle, Grasp the shuttle, and then pull it out

S2_brotherE.book Page 101 Thursday, February 13, 2003 11:03 AM

3Turn the balance wheel toward you until the tip of the shuttle hook aligns with the edge of the race shelf.

13 4

2

1Shuttle race

2 Shuttle

3 Edge of the shuttle race

4 Tip of the shuttle hook

•Be sure to turn the balance wheel toward you. Turning the balance wheel away from you may damage the machine.

4Remove the shuttle.

Grasp the shuttle, and then pull it out.

1

1Shuttle

5Use the cleaning brush or a vacuum cleaner to remove any lint and dust from the race and its surrounding area.

1

2

1Cleaning brush

2 Shuttle race

• Do not apply oil to the shuttle.

6Check that the edge of the race shelf is positioned as in step 3, and then insert the shuttle so that the projection on the shuttle aligns with the spring.

1

2

2

1

1 Projection

2 Spring

Insert the tabs on the needle plate cover into	4
7the needle plate, and then slide the cover back

on.

CAUTION

●Never use a shuttle that is scratched, otherwise the upper thread may become tangled, the needle may break or sewing performance may suffer. For a new shuttle (part code: XC3153-051), contact your nearest authorized service center.

●Be sure that the shuttle is correctly installed, otherwise the needle may break.

Maintenance 101