Brother CS 80 manual Upper threading is finished

S2_brotherE.book Page 23 Thursday, February 13, 2003 11:03 AM

•If the needle is not raised to the correct position, the needle cannot be threaded with the needle threader. Be sure to check that the thread cassette indicator is lit up in green before inserting the thread cassette.

2Insert the thread cassette into the thread cassette compartment.

Slowly press down on the thread cassette until it clicks into place.

1

1 Push here

11

1Needle bar thread hook

XAt the same time that the thread cassette is inserted, the needle is threaded.

XThe thread cassette indicator goes off.

•If the needle could not be threaded or the thread was not passed through the needle bar thread hook, refer to “ Loading the spool into the thread cassette” (page 19) and perform the procedure again starting from step 2.

CAUTION

●The needle threader is operated when the needle is threaded. Be sure to keep your hands and other items away from the needle, otherwise injuries may occur.

3Raise the presser foot lever, carefully pull on the loop of thread passed through the eye of the needle to pull out the end of the thread. Carefully pull the loop of thread toward the rear of the machine.

4Pass the thread through the presser foot, and then pull out about 10-15 cm (3/8-5/8 inch) of thread toward the rear of the machine.

1

110-15 cm (3/8-5/8 inch)

XThe upper threading is finished.

Upper Threading 23