S2_brotherE.book Page 14 Thursday, February 13, 2003 11:03 AM

GETTING READY ————————————————————————————————————————————————————————

Memo

When using thread that winds off quickly, such as transparent nylon thread or metallic thread, place the enclosed spool net over the spool before placing the spool of thread onto the spool pin.

If the spool net is too long, fold it to fit the size of the spool.

1

4

3

2

1Spool net

2 Spool

3 Spool pin

4 Spool cap

8Pull out some thread, and then thread the thread guide for bobbin winding.

Hold the thread with both hands, and then securely pass the thread as far as possible into the two slits in the thread guide.

1

9While using your left hand to hold the end of the thread that wraps around the thread guide for bobbin winding, use your right hand to wind the free end of the thread clockwise around the bobbin five or six times.

0Pull the thread to the right and pass it through the slit in the bobbin winder seat.

1

1Slit in bobbin winder seat (with built-in cutter)

XThe thread is cut to a suitable length.

CAUTION

Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out.

2

1Thread guide for bobbin winding

2 Two slits

14

Page 20
Image 20
Brother CS 80 manual Thread is cut to a suitable length