Brother CS 80 manual Place the button into button-sewing foot M, 5Select stitch

S2_brotherE.book Page 72 Thursday, February 13, 2003 11:03 AM

UTILITY STITCHES ———————————————————————————————————————————————————————

4Place the button into button-sewing foot “M”.

1

1Button

•When attaching four-hole buttons, first sew the two holes closest to you. Then, slide the button so that the needle goes into the two holes toward the rear of the sewing machine, and then sew them in the same way.

5Select stitch .

• For details, refer to “ Selecting stitching” (page 58).

6Adjust the stitch width so that it is the same as the distance between the holes in the button.

7Set the stitch length adjustment slider to the shortest stitch length setting.

8Turn the balance wheel toward you to check that the needle correctly goes into the two holes of the button.

Adjust the stitch width to the distance between the button holes.

CAUTION

●When sewing, be sure that the needle does not touch the button, otherwise the needle may bend or break.

9Start• Aftersewing.sewing for about 10 seconds at low

speed, press (reverse/reinforcement stitch button) to sew reinforcement stitches.

0Pull the upper thread at the end of the stitching to the wrong side of the fabric, and then tie it with the bobbin thread.

Use scissors to cut the upper thread and the bobbin thread at the beginning of the stitching.

aWhen you are finished attaching the button,

slide the drop feed lever to (to the left as seen from the front of the machine) to raise the feed dogs.

72