Brother CS 80 manual Threading the needle, Spool of thread is now loaded in the thread cassette

S2_brotherE.book Page 22 Thursday, February 13, 2003 11:03 AM

GETTING READY ————————————————————————————————————————————————————————

cPull the thread under the disc at the front in the lower-left corner and around to the right, and then cut the thread with the cutter. Follow arrow 6 indicated on the thread cassette.

1

2

1Disc

2 Cutter

XThe spool of thread is now loaded in the thread cassette.

Note

●Be sure to cut the thread as described above, otherwise the needle threader cannot be used to thread the needle.

Threading the needle

In this section, the procedures for installing the thread cassette and threading the needle are described. The needle threader is used to thread the needle at the same time that the thread cassette is inserted.

Memo

●The needle threader can be used with sewing machine needles 75/11 through 100/16.

●Thread with a thickness of 130/20 or less cannot be used with the needle threader.

●The needle threader cannot be used with the wing needle or the twin needle.

●If the needle threader cannot be used, refer to “ Threading the needle manually” (page 25).

1Check that the thread cassette indicator is lit up in green.

1

1Thread cassette indicator

If the thread cassette indicator is lit up in red, the needle has not been raised to the correct

position. Press (needle position button) once to raise the needle.

1

1 Needle position button

22