CAUTION
Installation
Setting up and moving of the printer should only be | Do not set up the printer in a place where it will be | |
carried out by a qualified technician. | affected by vibration. It may become unbalanced | |
The printer machine weighs approximately 111 kg | and fall down, which cause injury or damage to the | |
printer. | ||
(245 lb). Transporting and setting up of the printer | ||
| ||
should be held in proper way. | Do not connect the power cord until setup is | |
The machine may fall down and cause injury. | complete, otherwise the printer may operate if the | |
The printer must be used on a suitable stable | power switch is turned on by mistake, which could | |
result in injury. | ||
surface, otherwise it may tip over or fall down and | ||
| ||
cause injury. | Do not climb onto the printer or place heavy objects | |
Furthermore, the table that supports the printer | on top of it, otherwise it may become unbalanced | |
should be at least 137 cm (53.9 inch) in width and | and tip over or fall down and cause injury. | |
104.5 cm (41.1 inch) in depth, and should be able to |
| |
bear a weight of 150 kg (330 lb) or more. |
|
Printing
This printer should only be used by operators who | Do not move the Platen by hand. | |
are appropriately trained in its operation. | The Printer may be mechanically and electrically | |
Ensure there is adequate space left for safe working. | damaged. | |
| ||
The Platen moves forward while operating and it | Do not put your hands inside the covers while the | |
may be injured. | printer’s power is turned on, otherwise your hands | |
Do not handle the platen while printing. If your hand | may touch against moving parts and this may result | |
in injury. | ||
gets caught between the platen or the | ||
| ||
and the covers, it may be injured. | When a problem occurs with the operation of the | |
| printer, contact the place of purchase or a qualified | |
| technician. |
Wait at least 1 minute after turning off the power | Take care not to let the liquids: Ink, Wash Liquid, | |
switch before opening the front cover. | Maintenance Solution, Pretreatment or waste liquid | |
Do not touch the head heat sink as it may be HOT | come into contact with your eyes or onto your skin, | |
and may cause a burn. | otherwise inflammation can result. In case of contact | |
Be careful not to get your fingers caught when | with eyes, do not rub but immediately rinse the eyes | |
with water. | ||
closing the front cover, otherwise it may result in | ||
Furthermore, do not drink the liquids: Ink, Wash | ||
injury to your fingers. | ||
Liquid, Maintenance Solution, Pretreatment or waste | ||
| ||
Do not move the Platen by hand. | liquid under any circumstances, as they can cause | |
The Printer may be mechanically and electrically | vomiting and diarrhea. | |
damaged. | Keep the liquids out of the reach of children. | |
Do not disassemble the ink cartridge. | Be sure to wear protective goggles and gloves when | |
| handling the grease, so that they do not get into | |
| your eyes or onto your skin. If the grease get into | |
| your eyes or onto your skin, inflammation can result. | |
| Furthermore, do not drink or eat the grease. They | |
| may cause diarrhea or vomiting. | |
| Keep the grease out of the reach of children. | |
| When replacing parts and installing optional | |
| accessories, be sure to use only genuine Brother | |
| parts. | |
| Brother will not be held responsible for any | |
| accidents or problems resulting from the use of | |
|
iii |