ABOUT THIS PRINTER 1 - 32
6
Press and slide the paper-width guide to fit the envelope size.
Figure 1-39
7
Send the print data to the printer.
8
After you fini sh the print job, close the face-up output tray.
DL size double-flap envelopes
■If the DL size double f lap envelope is creased after printing, go to the Basic tab, select Paper
Size and then select DL Long Edge. Put a new DL size double-flap envelope in the MP tray with
the longest edge of the envelope in first, then print again.
When you put envelopes in the MP tray, please remember the following;
■During print ing, the inside tr ay rises to feed envelo pes into the printer.
■The side to be printed on must be face up.
■Put the right side edge of the envelope in first and push it gently into the tray.
■The top of t he envelope stack must be under the maximum paper he ight guides that are on b oth
sides of the tray.
■If envelopes get smudged during printing, in the pri nter driver sel ect MP Tray as the Paper
Source for a straight paper path. Then, set the Media Type to Thick Paper or Thicker Paper
to increase the fixing temperature. To adjust the print density setting, see Density adjustment on
page 2-8.
■Envelope joint s that are sealed by the manufacturer should be secure.
■All sides should be properly folded without any wrinkles or cr eases.