English
USER’S GUIDE
For errors shown below, the printer indicates an operator call by blinking the ALARM lamp and printing the error messages on paper.
Error | Action |
Memory Full | ∙ Press the FF/CONT switch to print the data |
| remaining in the printer. |
| ∙ If you are using the supplied Windows driver, try |
| again after changing the following settings. The |
| best combination of the settings below varies |
| depending on your document. |
| Graphics Mode |
| TrueType mode |
| User Printer TrueType™ Fonts |
| Page Protection |
| ∙ Expand the printer memory by adding a |
| commercially available SIMM. |
| ∙ Reduce the print resolution or reduce the complexity |
| of your document. |
Print Overrun | ∙ Press the FF/CONT switch to print the data |
| remaining in the printer. |
| ∙ If you use the supplied Windows driver, try again |
| after changing the following settings. The best |
| combination of the settings below varies depending |
| on your document. |
| Graphics Mode |
| TrueType mode |
| User Printer TrueType™ Fonts |
| Page Protection |
| ∙ If this does not clear the error, reduce the |
| complexity of your document or reduce the print |
| resolution. |
| ∙ Expand the printer memory by installing SIMM and |
| set page protection ON by using the supplied |
| Windows driver or RPC program. |
Centronics | ∙ Press the FF/CONT switch to resume printing. |
Interface Line | ∙ Check that the connection between your computer |
Error | and printer is secure and correct, and check the |
| interface cable. |
|
|
✒Note
If the printer does not operate as you expect it to, it is recommended that you perform a user reset or factory reset with the switches or unplug the printer, wait a few seconds and then plug it in again. If you still have problems, consult your dealer or our authorized service representative.
