English
USER’S GUIDE
Test Print Mode
The printer has a test print mode where you can select and perform any of three test prints. Follow these steps:
1.Press the SELECT switch to turn the printer
2.Hold down the FF/CONT switch and press the SELECT switch.
The printer enters the test print mode. The ALARM lamp blinks to indicate that the first choice, Test sample page, is selected. See the table below.
3.Press the FF/CONT switch to select another test.
Every time you press the switch, the blinking lamp changes to select another choice. See the table below.
4.Press the SELECT switch to perform the selected choice.
Blinking Lamp | Choice | Function |
ALARM | Test sample page | The printer prints a test |
|
| sample page. |
|
|
|
READY | Print Fonts I & P |
DATA | Print Config |
The printer prints a list of the internal or resident fonts of the printer. If permanent fonts are downloaded into the printer memory, the printer also prints a list of permanent download fonts.
The printer prints the current settings that configure or set up the printer.
MANUAL | Enable/disable the test | The test print set by TEST |
| switch is enabled or disabled. | |
|
|
|
After printing the desired test sample page, the printer returns to the ready status.
