Brother LW6091001 appendix Setting Bar Code Parameters, ZBar Code Settingsz

EDITING A LABEL

Setting Bar Code Parameters

1

Press the Setup key to display the Setup menu, select “Bar Code Setup” using the or key, and then press the OK or Enter key.

The Bar Code Setup screen is displayed.

2Select an attribute using the or key, and then set a value for that attribute using the or key.

Characters may not appear below the bar code even when "On" is selected for "Under #", depending on the tape width being used, the number of lines entered, or the current character style settings.

3Press the OK or Enter key to apply the settings.

New settings are NOT applied if you do not press the OK or Enter key.

• The "C-Digit" (Check Digit) attribute is only available for the CODE39, I-2/5 and CODABAR protocols

•Press the Escape key to return to the previous step.

•Press the Space key to set the selected attribute to the default value.

•Refer to the Bar Code Settings table for a list of all available settings.

	zBar Code Settingsz
Attribute	Value
Protocol	CODE39, CODE128, EAN-8, EAN-13,
	GS1-128 (UCC/EAN-128), UPC-A, UPC-E, I-2/5 (ITF),
	CODABAR
Width	Small
	Large
Under#	On
(characters printed
	Off
below bar code)
C.Digit	Off
	On
(check digit)	(only available for the CODE39, I-2/5
	and CODABAR protocols)

50

Creating a Bar Code Label