Press OK.
Press Print Settings.
Press Photo.
Open the media slot cover.

PhotoCapture Center™: Printing photos from a memory card or USB Flash drive

m Press d or c to adjust the degree of the setting.

Press OK.

n Do one of the following:

If you want to customize another color enhancement, repeat steps l and m.

Press .

If you want to change other settings,

press to display the print setting menu and press the setting you want to change. (See PhotoCapture Center™ print settings on page 65.)

o If you do not want to change additional

settings, press or OK. Press Start to print.

NOTE

•White Balance

This setting adjusts the hue of the white areas of an image. Lighting, camera settings and other influences will affect the appearance of white. The white areas of a picture may be slightly pink, yellow or some other color. By using this setting, you can correct that effect and bring the white areas back to pure white.

•Sharpness

This setting enhances the detail of an image, similar to adjusting the fine focus on a camera. If the image is not in true focus and you cannot see the fine details of the picture, then adjust the sharpness.

•Color Density

This setting adjusts the total amount of color in the image. You can increase or decrease the amount of color in an image to improve a washed-out or weak picture.

Cropping

If your photo is too long or too wide to fit the available space on your chosen layout, part of the image will be cropped.

The factory setting is On. If you want to print the whole image, change this setting to Off. If you set Cropping to Off, also set Borderless to Off. (See Borderless printing on page 70.)

a

b Put the memory card or USB Flash drive in the correct slot.

c

d Swipe left or right to display View Photos.

e Press View Photos.

 

Press OK.

8

f Swipe left or right, or press d or c to display each photo. When the photo you want is displayed, press it, and then press OK.

g h

i Swipe up or down, or press a or b to display Cropping.

j Press Cropping.

k Press Off (or On).

l If you do not want to change additional

settings, press or OK. Press Start to print.

69