Press Set New Default.
Press Scan to Media. Press Options.
Open the media slot cover.

PhotoCapture Center™: Printing photos from a memory card or USB Flash drive

NOTE

•Auto Crop is available for paper with

90-degree angles at all four corners. If one of the angles is not square, Auto Crop cannot detect the document.

•If your document is too long or wide, this setting does not work properly. The document has to meet the following specification: up to 10.6 × 16.54 in.

(270 × 420 mm).

If the ratio between the height and width of the document is more than 1 to 8, this setting does not work correctly.

•You must place the documents away from the edges of the scanner glass as shown in the illustration.

•You must place the documents at least 0.4 in. (10 mm) apart from each other.

•Auto Crop adjusts the skew of the document on the scanner glass, but if your document is skewed more than

10 degrees, this setting will not work.

•The ADF must be empty to use

Auto Crop.

•The Auto Crop feature is available for up to a maximum of 32 documents, depending on the documents' sizes.

•ADF High Speed Mode,

2-sided Scan and Skip Blank Page are not available with Auto Crop.

IMPORTANT

DO NOT take out the memory card or USB Flash drive while the machine is reading or writing to the memory card or USB Flash drive to avoid damaging the card, USB Flash drive, or the data stored on them.

How to set a new default

8

You can save the Scan to Media settings (ADF High Speed Mode, Scan Type, Resolution, File Type, Scan Size, Scan Long Paper, Auto Crop, Skip Blank Page and

Remove Background Color) you use most often by setting them as the default settings. These settings will remain until you change them again.

a

b Put the memory card or USB Flash drive in the correct slot.

c d

e Swipe up or down, or press a or b to

 

display ADF High Speed Mode,

8

Scan Type, Resolution,

File Type, Scan Size,

Scan Long Paper, Auto Crop,

Skip Blank Page or

Remove Background Color, and then press the setting you want to change. Then press the option you want to set.

Repeat this step for each setting you want to change.

f After you are finished choosing your preferred settings, swipe up or down, or press a or b to display

Set New Default.

g

h The Touchscreen asks you to confirm the change to the new default settings. Press Yes to confirm.

i Press .

73