Brother NX-450, N5V operation manual Basic stitching, Basic Stitching

————————————————————————————————————————————————————

Basic stitching

aBaste or pin together the fabric pieces.

bAttach zigzag foot “J”.

J

•For details, refer to “Replacing the presser foot” (page 41).

cSelect a stitch.

•For details, refer to “Selecting stitching” (page 72).

dLower the needle into the fabric at the beginning of the stitching.

eStart sewing.

•For details, refer to “Starting to sew” (page 52).

•For details on sewing reverse/reinforcement stitches, refer to “Securing the stitching” (page 54).

fWhen sewing is finished, cut the thread.

•For details, refer to “Cutting the thread” (page 55).

■ Changing the needle position

The needle position used as the baseline is different for the straight stitch (left needle position) and the straight stitch (center needle position).

1 2

aStraight stitch (left needle position)

bStraight stitch (center needle position)

When the stitch width of the straight stitch (left

needle position) is set to its standard setting3 (0.0 mm), the distance from the needle position to

the right side of the presser foot is 12 mm

(1/2 inch). If the stitch width is changed (between

0 and 7.0 mm (1/4 inch)), the needle position will also change. By changing the stitch width and sewing with the right side of the presser foot aligned with the edge of the fabric, a seam allowance can be sewn with a fixed width.

1

0.0 2.0 5.5 7.0

3 4 5 6

2

aStitch width setting

bDistance from the needle position to the right side of the presser foot

c12.0 mm (1/2 inch)

d10.0 mm (3/8 inch)

e6.5 mm (1/4 inch)

f5.0 mm (3/16 inch)

•For details, refer to “Adjusting the stitch width” (page 58).

Basic Stitching 81