Brother NX-450, N5V operation manual Correctly, reinsert the thread, GReattach the bobbin cover

————————————————————————————————————————————————————

Memo

zThe order that the bobbin thread should be passed through the bobbin case is indicated by marks around the bobbin case. Be sure to thread the machine as indicated.

The marks around the bobbin case differ depending on the model.

eLightly hold down the bobbin with your right hand, and then guide the thread as shown with your left hand.

CAUTION

●When installing the bobbin, be sure to hold it down with your finger. If the bobbin is not correctly installed, the thread tension will be incorrect.

fPass the thread through the slot as shown, and then pull the thread out toward the front.

1

aCutter

XThe cutter cuts the thread.

Note

zMake sure that the thread is correctly inserted through the tension-adjusting spring

of the bobbin case. If it is not inserted

correctly, reinsert the thread. 1

1

aTension-adjusting spring

gReattach the bobbin cover.

Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side.

2

1

XThe lower threading is finished.

Next, thread the upper thread. Continue with the procedure in “Upper Threading” (page 28).

Memo

zYou can begin sewing without pulling up the bobbin thread. If you wish to pull up the bobbin thread before starting to sew, pull up the thread according to the procedure in “Pulling up the bobbin thread” (page 36).

Winding/Installing the Bobbin 27