Brother N5V Operation buttons, a “Start/Stop” button, b “Reverse/Reinforcement Stitch” button

———————————————————————————————————————————————————

Operation buttons

The operation buttons help you to easily perform various basic sewing machine operations.

a“Start/Stop” button

Press the “Start/Stop” button to start or stop sewing. The machine sews at a slow speed at the beginning of sewing while the button is depressed. When sewing is stopped, the needle is lowered in the fabric. For details, refer to “Starting to sew” (page 52).

The button lights up in green, red or orange, depending on how the sewing machine is being operated.

Green:	When the machine is ready to start
	sewing or while it is sewing
Red:	When the machine is not ready to
	start sewing
Orange:	When the bobbin winder shaft is
	moved to the right for winding the
	bobbin thread onto the bobbin

b“Reverse/Reinforcement Stitch” button

Press the “Reverse/Reinforcement Stitch” button to sew reverse stitches or reinforcement stitches. Reverse stitches are sewn by keeping the button pressed down to sew in the opposite direction. Reinforcement stitches are sewn by sewing 3 to 5 stitches on top of each other. For details, refer to “Securing the stitching” (page 54).

c“Needle Position” button

Press the “Needle Position” button to raise or lower the needle. Pressing the button twice sews one stitch.

d“Thread Cutter” button

Press the “Thread Cutter” button after stopping sewing to cut both the upper and the bobbin threads. For details, refer to “Cutting the thread” (page 55).

eSewing speed controller

Slide the sewing speed controller to adjust the sewing speed.

CAUTION

●Do not press (“Thread Cutter” button) after the threads have already been cut, otherwise the needle may break, the threads may become tangled or damage to the machine may occur.

Note

zDo not press (“Thread Cutter” button) if there is no fabric under the presser foot or while the machine is sewing, otherwise damage to the machine may occur.

zWhen cutting thread thicker than #30, nylon thread or other special threads, use the thread cutter on the side of the machine. For details, refer to “Cutting the thread” (page 55).

12