Brother NX-450, N5V operation manual NPress Start/Stop button once

————————————————————————————————————————————————————

kWhile holding the thread with your left hand, wind the thread that was pulled out clockwise around the bobbin five or six times with your right hand.

Note

zMake sure that the thread between the spool and the bobbin is pulled tight.

zBe sure to wind the thread clockwise around the bobbin, otherwise the thread will become wrapped around the bobbin winder shaft.

lPass the end of the thread through the guide slit in the bobbin winder seat, and then pull the thread to the right to cut it.

1

aGuide slit in bobbin winder seat (with built-in cutter)

XThe thread is cut to a suitable length.

CAUTION

●Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin and the needle may bend or break when the bobbin thread starts to run out.

mSlide the sewing speed controller to the right to increase the bobbin winding speed and slide to left to decrease.

1

1

aSewing speed controller

nPress (“Start/Stop” button) once.

1

a“Start/Stop” button

•When the bobbin winding becomes slow,

press (“Start/Stop” button) once to stop the machine.

CAUTION

●When the bobbin winding becomes slow, stop the machine, otherwise the sewing machine may be damaged.

oUse scissors to cut the end of the thread wound around the bobbin.

pSlide the bobbin winder shaft to the left.

Winding/Installing the Bobbin 25