Brother PC 3000 operation manual Spring on the shaft 2 Groove of the bobbin, Bobbin winder seat

3.Pass the thread through the thread guide as shown by the arrows.

2

1

1

2

1

2

3

1

4.Align the groove in the bobbin with the spring on the shaft and place the bobbin on the bobbin winder shaft. Then, push the bobbin winder shaft to the right.

1Spring on the shaft

2 Groove of the bobbin

5.Wind the thread clockwise around the bobbin four or five times, pass the end of the thread through the slit in the bobbin winder seat, and then pull the thread in the direction shown in the illustration. Use the cutter to cut the thread.

1Bobbin winder seat

6.Slide the speed range control lever to its maximum (as far to the right as possible).

7.Press the “START/STOP” button. The machine will stop auto- matically when the bobbin is full.

8.After the bobbin has stopped moving, press the “START/STOP” button to stop the machine.

9.Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.

Note

Immediately after winding the bobbin, it is normal to hear the sound of the clutch engaging when beginning to sew or manually turning the balance wheel.

14