Brother PC 3000 operation manual Dart Seam, Basting

DART SEAM

01

1

J

1.Attach presser foot “J”, then sew a reverse stitch at the begin- ning of the dart and sew from the wide end to the narrow end without stretching the fabric.

1Basting

*Before sewing, touch the automatic reinforcement stitching key to sew reinforcement stitches automatically at the begin- ning of the stitch.

2.Do not sew a reinforcement stitch at the end. Cut the thread at the end leaving an excess 5 cm (2"), and then tie both ends together.

3. Insert the ends of the thread into the dart using a needle.

*Alternate method: When you reach the narrow end of the dart; stop, lift the presser foot, slide your fabric towards you (19 mm). Touch the stitch length keys, reduce to 0.4 mm. Sew 3 stitches on the seam line. This will secure the thread ends, cut the thread.

4. Iron the dart to one side so that it is flat.

60