Brother PC 3000 Metal bracket on the buttonhole foot, Normal buttonhole and rounded buttonhole

5

6

1

5

6

4.Lower the buttonhole lever and position it behind the metal bracket on the buttonhole foot.

1Metal bracket on the buttonhole foot

5.While lightly holding the end of the upper thread, press the “START/STOP” button to start sewing.

*Gently feed the fabric by hand.

*Before stopping, the machine will automatically sew a rein- forcement stitch after the buttonhole is sewn.

*If the fabric does not feed (for example, because the fabric is

too thick), touch the “ ” stitch length key to increase the stitch length.

6. Open the buttonhole.

Normal buttonhole and rounded buttonhole

Insert a pin in front of the inside edge of both bar tacks. Insert the seam ripper into the center of the buttonhole and cut toward the first pin, then cut toward the other pin.

1Pin

Keyhole buttonhole

Make a hole using the small eyelet punch in the key end, then insert a pin in front of the inside edge of the bar tack. Insert a seam ripper into the hole made with the eyelet punch and cut towards the pin.

1Small eyelet punch (accessory #9 on page 6)

2 Pin

44