Brother TD4000, TD4100N manual Setting the RD Roll

12STEP1 Getting started

7 Setting the RD Roll

1

Press and hold the ON/OFF button () to turn the TD-4000/4100N off. Pull up the left and right levers on the TD-4000/4100N under the RD Roll compartment cover, and open the RD Roll compartment cover.

2

Squeeze the green lever and adjust the guide to fit the width of the RD roll. Use the scale molded in the rear compartment to assist positioning this guide.

3

Slide the end of the RD roll under the gap (media) sensor.

If the end of the RD roll has not been fed under the gap (media) sensor, the TD-4000/4100N may not be able to detect the media properly.

Gap sensor

4

Insert a RD roll into the roll compartment upside down with the labels feeding from the bottom as shown.

Check the position of the roll guide and adjust it to prevent the RD roll from moving sideways.

Incorrect insertion of the RD roll will not print on the correct side of the label.