C. Condenser-Fan Motor Protection
Each
D. High- and Low-Pressure Switches
If either switch trips, or if the compressor overtemperature switch activates, that refrigerant circuit will be automati- cally locked out by the CLO. To reset, manually move the thermostat setting.
E. Freeze Protection Thermostat (FPT)
An FPT is located on the top and bottom of the evaporator coil. They detect frost
XIV. RELIEF DEVICES
All units have relief devices to protect against damage from excessive pressures (i.e., fire). These devices protect the high and low side.
XV. CONTROL CIRCUIT, 24-V
This control circuit is protected against overcurrent by a
3.2amp circuit breaker. Breaker can be reset. If it trips, determine cause of trouble before resetting
XVI. REPLACEMENT PARTS
A complete list of replacement parts may be obtained from any Carrier distributor upon request.
XVII. DIAGNOSTIC LEDS
The IGC control board has a LED for diagnostic purposes. The IGC error codes are shown in Table 15.