BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
Keyfobs and Keypads
When adding new Keyfobs or Keypads to your system, you only need to allocate them a number.
With Keyfobs, it is important that you make sure the number corresponds to the User Code number on the Control Panel and your personal account. This will ensure your BT Home Monitoring system works correctly and gives you the best information.
Add / Delete / Change Sensor
ADDING AND NUMBERING A SENSOR
At the Control Panel, follow these instructions:
| PRESS | DISPLAY |
| NEXT | Until the display shows |
|
| |
|
| SYSTEM PROFILE. |
|
|
For example:
| User Code | Keyfob | Online Account |
|
|
|
|
Person 1 | Master Code | 1 | User 1 |
|
|
|
|
Person 2 | User Code 2 | 2 | User 2 |
|
|
|
|
Person 3 | User Code 3 | 3 | User 3 |
SHOW / OK
NEXT
SHOW / OK
Enter your MASTER CODE – if you have not selected a personal PIN number, this will be the default setting – 2580.
Until display shows
ADD / DEL SENSOR.
Display shows SENSOR
Person 4 | User Code 4 | 4 | User 4 |
|
|
|
|
Person 5 | User Code 5 | 5 | User 5 |
|
|
|
|
Person 6 | User Code 6 | 6 | User 6 |
|
|
|
|
Person 7 | User Code 7 | 7 | User 7 |
|
|
|
|
Person 8 | User Code 8 | 8 | User 8 |
SHOW / OK
SHOW / OK
Enter the Sensor number you want e.g. 4, or press NEXT to find the next available Sensor location.
As the BT Home Monitor has three Sensors supplied, numbers 1, 2 and 3 are already taken and a black box ■ will appear next to the number signifying that the slot has been taken. You can add additional Sensors from the number 4 slot onwards.
Display shows S (number):
ADD SENSOR.
Display shows ACTIVATE NOW. Switch the sensor on. This depends on the type of sensor, but usually involves activating the battery.
Display shows S (number): and a black box is displayed. The sensor is now registered. You will now need to choose the settings for your detector. Where S (number): is shown, this refers to the sensor number you have given your detector.
SECTION 5
39
