OPERATING THE DISPENSER
Set the Function Selector Switch to “Normal” and the Mode Selector Switch to “Run.”
1A. Push and Hold Dispense Mode (Cup at a time). See Programming Functions to set this amount.
a.Place cup on the tray beneath the dispensing tip.
b.Push and hold the corresponding dispense switch until the container is full.
c.Remove cup or container.
1B. Portion Dispense Mode. (Cup dispense volume preset to a desired amount) Refer to Programming Functions to set this amount.
a.Place cup on the tray beneath the dispensing tip.
b.Momentarily press the desired dispense switch. The dispenser will automatically dispense the beverage at the preset amount. Allow the mix chamber to drain at the end of the cycle.
c.Remove cup.
2.Carafe Dispense Mode. Refer to Programming Functions to set this volume.
a.Place the appropriate size container beneath the dispensing tip.
b.Momentarily press the Portion Switch. The Portion LED will illuminate for 5 seconds after the Portion Switch is pressed.
c.Momentarily press the desired dispense switch. If the user waits longer than 5 seconds to push the switch, the dispenser will default back to the cup dispense mode. The carafe dispense mode can be disabled at any time during the dispense by either momentarily pushing the Dispense Switch again or pressing the Stop button.
d.Wait for the container to fill and the dispenser to quit dispensing, then remove the container.
3.Hot Water Dispense
a.Place a container under the dispense tip.
b.Push and hold the Hot Water switch until water reaches the desired level, then release.
c.Remove the container.
17 | 39288 083106 |
|
