Bunn LCC-2 C1 r un, C2 r un, C3 r un, C4 r un, Calibrating The Dispenser, Calibration Mode

CALIBRATING THE DISPENSER

NOTE: The LCA-2 LP is calibrated at the factory and does not normally need to be re-calibrated. To enter the Calibration Mode, Set the RUN/NIGHT/PROGRAM Switch to the PROGRAM position and then hold the “MENU” switch down for 10 seconds.

LCD DISPLAY

C1 r un

MENU (-) (+)

C1 2 2

MENU (-) (+)

C2 r un

MENU (-) (+)

C22 2

MENU (-) (+)

C3 r un

MENU (-) (+)

C3 1.08

MENU (-) (+)

CALIBRATION MODE	DESCRIPTION
Left (Regular) Pump Cal.	Set PRIME-NORMAL-RINSE switch
	to PRIME position. Press and hold
	Regular Dispense Switch until pump
	stops (20 sec.) Refer to Field Calibration
	of the Concentrate Pumps.
Left (Regular) Pump Cal.	Enter mL collected from the 20 sec.
	test above.
	Default = 22
	Range = 18 - 26mL
Right (Decaf) Pump Cal.	Set PRIME-NORMAL-RINSE switch to
	PRIME position. Press and hold Decaf
	Dispense Switch until pump stops (20
	sec.) Refer to Field Calibration of the
	Concentrate Pumps.
Right (Decaf) Pump Cal.	Enter mL collected from the 20 sec.
	test above.
	Default = 22
	Range = 18 - 26mL
Left (Regular) Water Rate	Set PRIME-NORMAL-RINSE switch to
	RINSE position. Press and hold Regular
	Dispense Switch until flow stops (20
	sec.) Refer to Field Calibration of the
	Concentrate Pumps.
Left (Regular) Water Rate	Enter Liters collected from the 20 sec.
	test above.
	Default = 1.08
	Range = 0.95 - 1.12 Liters

C4 r un

MENU (-) (+)

Right (Decaf) Water Rate	Set PRIME-NORMAL-RINSE switch to
	RINSE position. Press and hold Decaf
	Dispense Switch until flow stops (20
	sec.) Refer to Field Calibration of the
	Concentrate Pumps.

20 39288 072707