Manuals / Cabletron Systems / Computer Equipment / Switch

Cabletron Systems INSTALLING THE HSIM-W87, Installing the HSIM-W87 in an Interface Module

Models: HSIM-W87

1 56

Download 56 pages 28.96 Kb

Page 20

2.2INSTALLING THE HSIM-W87

Chapter 2: Installation

2.2INSTALLING THE HSIM-W87

Only qualiﬁed personnel should install or service this unit.

An HSIM-W87 can be installed in any Cabletron Systems device that supports HSIM technology (e.g., 2H252-25R, 2E42-27, 6E132-25).

NOTE

Refer to the release notes for the version of ﬁrmware running on the Cabletron Systems host platform to ensure that the HSIM-W87 is supported.

The following subsections provide instructions for installing an HSIM-W87 in a host platform. Refer to the speciﬁc interface module or standalone device document for exact HSIM slot and connector locations.

2.2.1Installing the HSIM-W87 in an Interface Module

To install an HSIM-W87 in an interface module that supports HSIM technology, perform the following steps.

1.Note the ports of the interface module that have cables attached to them. Write down the ports and label the cables to make it easier to reattach the network properly after the installation. Then disconnect those cables from the ports.

2.Attach the antistatic wrist strap (refer to the instructions outlined on the antistatic wrist strap package).

3.If the interface module is installed in a chassis, unlock the top and bottom plastic locking tabs of the module faceplate.

4.Remove the module from the chassis, and place it down flat with the internal components facing up.

5.Remove and save the two faceplate mounting screws securing the HSIM coverplate and remove the coverplate. See Figure 2-1.

2-2	HSIM-W87 User’s Guide

Image 20

Cabletron Systems manual INSTALLING THE HSIM-W87, Installing the HSIM-W87 in an Interface Module

Contents

HSIM-W87 T3 TXRX LNK CPU STSTELCO HSIM-W87 User’s Guide9032689-02 Page HSIM-W87 User’s Guide Only qualiﬁed personnel should perform installation proceduresFCC NOTICE INDUSTRY CANADA NOTICE VCCI NOTICECABLETRON SYSTEMS, INC. PROGRAM LICENSE AGREEMENT HSIM-W87 User’s GuideEXCLUSION OF WARRANTY AND DISCLAIMER OF LIABILITY CABLETRON SOFTWARE PROGRAM LICENSEUNITED STATES GOVERNMENT RESTRICTED RIGHTS HSIM-W87 User’s GuideHSIM-W87 User’s Guide CONTENTS INSTALLATIONCHAPTER INTRODUCTIONContents TROUBLESHOOTINGSPECIFICATIONS TYPICAL CONFIGURATIONImportant Notice 1.1 USING THIS MANUALCHAPTER INTRODUCTION 1.2 OVERVIEW Chapter 1 IntroductionThe HSIM-W87 operates in two modes Switching IMUX 1.4.1 Connectivity 1.4 FEATURES1.3 DATA FLOW IN THE HSIM-W87 1.4.2 HDLC 1.4.3 Inverse Multiplexing IMUX1.4.6 SNMP and MIB Support 1.4.5 DS1 Alarm1.4.4 Priority Queuing 1.4.7 LANVIEW Diagnostic LEDs 1.5 DOCUMENT CONVENTIONS1.6 RELATED DOCUMENTATION bold type1.7 GETTING HELP HSIM-W87 User’s Guide Chapter 1 Introduction1-10 CHAPTER INSTALLATION 2.1 UNPACKING THE HSIM-W87Only qualiﬁed personnel should install or service this unit 2.2 INSTALLING THE HSIM-W872.2.1 Installing the HSIM-W87 in an Interface Module Installing the HSIM-W87 HSIM-W87 User’s GuideFigure 2-1 Removing the HSIM Coverplate HSIM Coverplate Faceplate Mounting Screws Host Platform7. Align the connector on the HSIM-W87 with the pins on the module 2.2.2 Installing the HSIM-W87 in a Standalone Device HSIM-W87 User’s Guide 2.3 CONNECTING THE HSIM-W87 TO THE NETWORK2.4 HSIM-W87 SETUP HSIM-W87 User’s Guide CHAPTER LANVIEW LEDs3.1 LANVIEW LEDS HSIM-W87 LEDs Chapter 3 LANVIEW LEDsHSIM-W87 User’s Guide CHAPTER MANAGEMENT 4.1 LOCAL MANAGEMENTChapter 4 Management HSIM-W87 User’s GuideFigure 4-1 Typical Hierarchy of Local Management Screens 2555hierdsx1 - support for RFC 1406 statistics and conﬁguration 4.2 NETWORK TOOLSImportant Notice 4.2.1 Commands command 4.2.2 Built-in Commands Example Example command wanpqSyntax wanpq wanpq -ea wanpq -da Example command ds1alarm Syntax ds1alarmVALUE sei sets the Errored Seconds Threshold Interval to VALUE command dsx1 Syntax dsx3 dsx3 near dsx3 near command dsx3Example Example dsx34.2.3 Special Commands SyntaxDescription Options4.3 SAMPLE IMUX CONFIGURATION Enter imux 1 -eg Chapter 4 Management 4-16HSIM-W87 User’s Guide Figure 4-5 Enabling the IMUX Application5.1.1 Hardware Troubleshooting CHAPTER TROUBLESHOOTING5.1 TROUBLESHOOTING THE HSIM-W87 Verify the framing, zero suppression, and T3 clock source Device not forwarding packets 5.1.2 Investigating Software Conﬁguration Problems5.1.3 Problems with the Firmware Image Chapter 5 Troubleshooting HSIM-W87 User’s GuideAPPENDIX A SPECIFICATIONS A.1 PHYSICAL PROPERTIESA.2 ENVIRONMENTAL REQUIREMENTS HSIM-W87 User’s GuideA.3 REGULATORY COMPLIANCE SafetyAppendix A Speciﬁcations ElectromagneticAPPENDIX B TYPICAL CONFIGURATION Figure B-1 HSIM-W87 IMUX Operational Appendix B Typical ConﬁgurationHSIM-W87 User’s Guide APPENDIX C WAN TERMS AND ACRONYMS CPE - Customer Premises Equipment DSX-1 - Short-haul version of DS1coaxial cable being used as the media deﬁnes it as short-haul by deﬁnition, coaxial cable is short-haul LLB - Line Loop Back, a full T1 loopback on D4 or ESF framed lines PLB - Payload Loop Back, ESF loopback including the facilities datalink WAN - Wide Area Network, a network spanning a large geographic area