Cabletron Systems HSIM-W87 manual Sample Imux Configuration, Imux 1 -ac 1

Chapter 4: Management

4.3SAMPLE IMUX CONFIGURATION

The following is a sample of a common configuration.

To perform an IMUX configuration for the setup shown in Figure B-1, in Appendix B, follow these steps:

1.To add channels to an IMUX group: Enter: imux 1 -ac 1 29

(this adds interface 29 to the group id 1 in the imux id 1) To display the setup so far:

Enter: imux 1

Figure 4-3shows the imux setup for group id 1 so far:

->imux 1 -ac 1 29

#Inverse Multiplexer channel with ifIndex 29 added to group 1 -> imux 1

#

#WAN Inverse Multiplexer 1 Status: Disabled

#		Inverse		WAN	Available	Xmit Byte		Inverse
# Multiplexer			Group	Physical	BW	Count	Multiplexer		Channel
#	ID	Admin	Status	Number	(bits/sec)	(bytes)	ID	IfIndex	Status
#	-------------------------------------------------------------------------------------------------------------
#	1	Disabled		22	1536000	0	1	29	INACTIVE
#
#

#Number of WAN Inverse Multiplexer Groups currently programmed : 1

#Number of WAN Inverse Multiplexer Channels currently programmed : 1

imuxsetup1

Figure 4-3 Adding Channels to an IMUX Group

4-14 HSIM-W87 User’s Guide