Chapter 6 Command Reference
Command Details
mwam module cpu logging
To configure the severity level of MWAM logging information to send to the Supervisor module, use the mwam module cpu logging command in global configuration mode. To remove this configuration, use the no form of the command.
mwam module {slot_number all} cpu {processor_number all} logging log_level
no mwam module {slot_number all} cpu {processor_number all} logging log_level
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
slot_number all | Specifies the slot that the module is plugged into or all MWAMs in the |
| chassis |
|
|
cpu_number all | Specifies the processor on the MWAM or all processors on the MWAM. |
|
|
log_level | Limits the logging of messages to be sent to the Supervisor to a specified |
| level (e.g., if log_level is critical, then emergencies, alerts, and critical |
| events are sent). You can enter the level number or name. |
| • emergencies (severity level |
| • alerts (severity level 1)— immediate action required |
| • critical (severity level |
| • errors (severity level |
| • warnings (severity level |
| • notifications (severity level |
| • informational (severity level |
| • debugging (severity level |
|
|
The default configuration is logging enabled on all MWAM processors for emergencies.
Global configuration.
ReleaseModification
12.2(14)ZA4 | This command was introduced. |
|
|
Logging methods may require additional configuration such as the destination IP address for the receiver of the log traffic. To configure the destination IP address, use the logging
The following example sets the logging level for all MWAM processors in the chassis to the error logging level:
Sup-7600(config)# mwam module all cpu all logging error
Multiprocessor WAN Application Module User Guide
|
| ||
|
|
