6-7
Multiprocessor WAN Application Module User Guide
OL-4858-07
Chapter6 Command Reference Command Details
show mwam moduleTodisplay connectivity information about the individual processors on the MWAM,use the show mwam
module command in privileged EXEC mode.
show mwam module slot_number port port_number {state | traffic}
Syntax Description
Defaults There are no default behavior or values.
Command Modes EXEC mode.
Command History
Examples The following example illustrates theshow mwam module command:
Sup-7606#sho mwam mod 7 port 1 state
Mwam module 7 data-port 1:
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: dot1q
Negotiation of Trunking: Off
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: 1-999
Pruning VLANs Enabled: 2-1001
Vlans allowed on trunk:1-999
Vlans allowed and active in management domain:1,3,11-12,17,60
Vlans in spanning tree forwarding state and not pruned:
1,3,11-12,17,60
Allowed-vlan : 1-999
Sup-7606#sho mwam mod 7 port 1 traffic
Specified interface is up line protocol is up
Hardware is C6k 1000Mb 802.3, address is 0010.7b00.0cb0 (bia 0010.7b00.0cb0)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
Last input never, output never, output hang never
slot_number Displays the slot that the module is plugged into.
port port_number Displays the actual port number (1-3) used to connect to a processor
complex within an MWAM (Figure1-1).
state Displays the interface status.
traffic Displays the interface statistics.
Release Modification
12.2(9)ZA This command was introduced.