Network Tools
The Network Tools functions are performed using a series of commands. Entering commands in Network Tools involves typing the command at the Network Tools prompt, adding any required parameters, and pressing ENTER to execute the command.
There are two categories of commands in the command set.
•
•Special Commands – Allow the user to exit from Network Tools. The commands are done, exit, and quit. All three commands perform the exact same function.
NOTE |
The conventions used in describing the commands in Network Tools are as follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by the user is shown in bold Helvetica font.
To abort the output or interrupt a process, press the CONTROL key and c key simultaneously, designated as ^C here.
The commands are presented in the following format:
command:
Syntax: Shows the required command format. It indicates where arguments, if any, must be specified.
Description: Briefly describes the command and its uses.
Options: Lists any additional fields in the appropriate format that may be added to the command.
Example: Shows an example of how to use the command.
|
