Cabletron Systems NBR-420, NBR-220 manual Unsaved Initialization Messages, Static System Messages

Using the LCD

4.3.1 Unsaved Initialization Messages

Unsaved Initialization messages are generated during power-up and appear as the event occurs. These messages track the boot up sequence. They are not saved and cannot be recalled.

Cabletron	Cabletron
Hardware Init	Boot From Flash
Cabletron	Cabletron
BOOTP Discovery	RARP Req. State
Cabletron	Cabletron
TFTP Req. State	TFTP in Progress
Cabletron	Cabletron
TFTP Complete	Erasing Flash
Cabletron	Cabletron
Programming Flash	Flash Programmed
Cabletron	Cabletron
Boot Complete	Test in Progress

4.3.2 Static System Messages

Static System messages provide NBR configuration information. The product name must be displayed on the LCD before you can start stepping through the messages in the sequence shown in this section.

NOTE

Whether you are displaying Static System messages, Alarm messages, or Saved System messages, the display returns to the product name display 20 seconds after the last operation of the DISPLAY button.

To Display the Messages

With the product name displayed, momentarily press the DISPLAY button to step to the first message. Each time you press the DISPLAY button, the next message is displayed until the last message. Then the display automatically exits to the product name.

NBR-SERIES Installation Guide Page 4-7