Cadillac 2010 owner manual Starting the Engine Using Remote Start, Extending Engine Run Time

1-10 Keys, Doors and Windows

Laws in some local communities may restrict the use of remote starters. For example, some laws may require a person using remote start to have the vehicle in view. Check local regulations for any requirements.

There are other conditions which can affect the performance of the transmitter, see Remote Keyless Entry (RKE) System on page 1‑ 3 for additional information.

Starting the Engine Using

Remote Start

To start the engine using the remote start feature:

1.Press Q on the RKE transmitter.

2.Within three seconds, press and hold / until the turn signal lamps flash. This confirms the request to remote start the vehicle has been received. If the vehicle' s lamps are not visible, press and hold / for at least two seconds.

During the remote start the vehicle's doors will be locked and the parking lamps will remain on as long as the engine is running.

3.Press the brake pedal and select the ON/RUN/START ignition mode to drive the vehicle.

The engine will shut off after 10 minutes unless a time extension is done or the ignition is put in ON/RUN/START.

Extending Engine Run Time

For a 10 minute extension, repeat Steps 1 and 2 while the engine is still running. The remote start can only be extended once.

When the remote start is extended, the second 10 minute period will start immediately.

For example, if the vehicle has been running for five minutes, and

10 minutes are added, the engine will run for a total of 15 minutes.

A maximum of two remote starts or remote start attempts are allowed between ignition cycles.

The vehicle's ignition must be changed to ON/RUN/START and then back to OFF before the remote start procedure can be used again.

Shutting the Engine Off After a Remote Start

To cancel a remote start:

.Press / until the parking lamps turn off.

.Turn on the hazard warning flashers.

.Turn the ignition on and then back off.

Conditions in Which Remote Start Will Not Work

The remote start will not operate if:

.The ignition is in any mode other than OFF.

.The transmitter is in the vehicle.

.The hood is not closed.