Operating Instructions and Parts Manual
a.When servicing a tool, use only identical replacement parts. Use only authorized parts.
NOTE: The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
•Is the water hose attached to the pressure washer?
•Is the water turned on?
•Check for any kinks, leaks, or blockage in the hoses, fittings, or the nozzle.
•Is the quick connect tip in place? (See Page 10).
•Is the inlet filter screen free of debris? Check and remove debris if needed.
•Use any color tip except black. The black tip is only used for low pressure detergent application.
1.Connect the clear plastic chemical suction tube to the plastic hose barb on pump, insert the other end into your detergent.
2.Install the black spray tip to apply low pressure detergent.
Detergents “bounce” off cleaning surfaces as fast as they are applied. The pressure washer’s features allow for a detergent to be drawn while in low pressure mode only. By applying detergent at low pressure, the effect of “bouncing” is reduced. Also, detergents are only effective when time is allowed for them to work on the surface of whatever is being cleaned. After applying the detergent, wait
1.After turning off the pressure washer and the water, depressurize the hose by triggering the gun.
2.Remove the garden hose and high pressure hose from the pump.
3.Turn the motor on for 5 seconds to purge water from the pump. This will help protect the pump from damage.
4.Do not store your pressure washer in an area where the temperature will drop below 32˚ F.
5.Follow proper storage and winterizing instructions found on pages 13 and 14.
Call Campbell Hausfeld at
•If you can’t find accessories at the store where you purchased your pressure washer, call Campbell Hausfeld
Call Campbell Hausfeld
6www.chpower.com