Installing and Removing the Battery and Card

Load a fully charged Battery Pack LP-E10 into the camera. The camera can use an SD, SDHC, or SDXC memory card (sold separately). The captured images are recorded onto the card.

Make sure the card’s write-protect switch is set upward to enable writing/erasing.

Installing the Battery and Card

1

2

Write-protect switch

3

Open the cover.

Slide the lever as shown by the arrows and open the cover.

Insert the battery.

Insert the end with the battery contacts.

Insert the battery until it locks in place.

Insert the card.

As shown by the illustration, face the card’s label side toward the back of the camera and insert it until it clicks in place.

4 Close the cover.

Press the cover until it snaps shut. When you set the power switch to <1>, the number of possible shots (p.36) will be displayed on the LCD monitor.

32