Chapter 8 ISIS/TWAIN Driver Settings
Patchcode Orientation (ISIS Driver Only)
This function is enabled when batch separation is set to [Patchcode]. Set the orientation to match that of the patchcode of the patchcode sheet.
Hint
[Patchcode Orientation] must be set as follows to match that in the document.
Flatbed |
|
| |
Document: |
|
| |
Face Down |
|
| |
Feeder |
|
| |
Document: |
|
| |
Face Up |
|
| |
Patchcode |
|
| |
Sheet |
|
| |
Patchcode | 0 degrees | 90 degrees 180 degrees 270 degrees | |
Orientation | |||
|
|
Stamp
This function is for affixing the scanned stamp to scanned documents in the feeder, and is displayed when the optional stamp is installed.
Select this check box to affix the scanned stamp to following position of scanned documents.
•Stamp side: Scanned side(s) (both sides when both sides are scanned)
•Stamp position: A position approximately 0.4" (10 mm) from the end at the rear in terms of the feed direction
•Stamp pattern: 
(Diameter of approximately 0.1" (3 mm))
Hint
The pattern and position of the stamp cannot be changed.
Prescan
Prescan and display the first document page in the Prescan window when scanning is started. Continue scanning after you confirm or adjust the brightness and contrast of the scanned image in the Prescan window.
Buttons
[OK] button
Click this button to accept changes and close the Basic Setup dialog box.
[Cancel] button
Click this button to reject changes and close the dialog box.
[Help] button
Click this button to display help for this dialog box.