Canon LV-5200 owner manual Troubleshooting, Problem, Try these Solutions, Appendix

APPENDIX

TROUBLESHOOTING

Before calling your dealer or service center for assistance, check the following:

●Make sure you have connected the projector to peripheral equipment as described properly in the section “CONNECTING THE PROJECTOR” on pages 11 ~ 13.

●Verify that all computer, video and power cord are properly connected and turn the equipment on.

●When you are operating the projector with a computer and it does not produce an image, restart the computer.

●Select the other input source.

Problem:	Try these Solutions
No power.	● Plug the projector into an AC outlet.
	● Make sure the READY Indicator lights.
	● Wait 90 seconds after the projector is turned OFF before turning the projector back on.
	NOTE : After pressing the Power ON-OFF button to OFF, make sure the projector works as
	follows:
	1. The LAMP indicator lights bright and the READY indicator turns off.
	2. After 90 seconds, the READY indicator lights green again and the projector can
	be turned on by pressing the Power ON-OFF button.
	● Check the WARNING TEMP. indicator. If this indicator flashes red, the projector cannot
	be turned on.
	(See the “TURNING ON/OFF THE PROJECTOR” section on page 19.)
	● Check the Projection Lamp. (Refer to page 38.)
Image is out of	● Adjust the focus of the projector.
focus.	● Make sure a projection screen is at least 3.6’ (1.1m) from the projector.
	● Check the Projection Lens to see if it needs cleaning.
	NOTE : Moving the projector from a cool temperature location to a warm temperature
	location may result in moisture condensation on the Projection Lens. In such an
	event, leave the projector OFF and wait until condensation disappears.
Picture is Left/Right	● Check Ceiling / Rear feature. (See the “SETTING” section on page 36.)
reversed.
Picture is	● Check Ceiling feature. (See the “SETTING” section on page 36.)
Top/Bottom
reversed.
Some displays are	● Check Display feature.(See the “SETTING” section on page 36.)
not seen during the
Operation.
No image.	● Check the connection between your computer or video equipment and the projector.
	● Check the NO SHOW function. (Refer to P21.)
	● When turning the projector on, it takes about 30 seconds to display an image.
	● Check the system that you select is corresponding with your computer or video
	equipment.
	● Make sure the temperature is not out of the Operating Temperature (5°C ~ 35°C).
No sound.	● Check the audio cable connection from the audio input source.
	● Adjust the audio source.
	● Press the VOLUME (+) button.
	● Press the MUTE button.
Computer 1 cannot	● Check RGB IN 1 / OUT terminal is set as COMPUTER 1. (See the “SETTING” section
be selected.	on page 36.)

42