SETTING
Ceiling
When this function is “On,” the picture is top/bottom and left/right reversed. This function is used to project the image from a ceiling- mounted projector.
Rear
When this function is “On,” the picture is left/right reversed. This function is used to project the image to a rear projection screen.
Anamorphic
When this function is “On,” the screen image is forcibly changed to the 4:3 image, even if the input signal is HDTV.
Ceiling |
Rear |
Simple menu
When this function is “On,” the value adjustment bar in the picture IMAGE ADJUSTMENT Menu is displayed on the bottom left of the screen.
Menu position
This function is used to adjust the
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not used for a certain period.
If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with “No signal” appears on the screen to start the countdown. The countdown time can be set between 1 and 30 minutes.
Select one of the following operations:
Ready . . . . . When the lamp has been fully cooled down, the READY indicator starts blinking. In this condition, the projection lamp is turned on if the input signal is reconnected or any button on the top control or remote control unit is pressed.
Shutdown . . When the lamp has been fully cooled down, the power is turned off.
Off . . . . . . . The Power management function is off.
Power management
Time left until lamp off
Press the OK button at Power management and this box appears. Choose one of three settings with the POINT LEFT/RIGHT buttons, and go to the timer with the POINT DOWN button and set time with the POINT LEFT/RIGHT buttons.
40
