Canon LV-7575 user manual Lamp Replacement, Order Replacement Lamp

Connect the AC power cord to the projector and turn on the projector.

Turn off the projector and unplug the AC power cord. Allow the projector to cool for at least 45 minutes.

Loosen the two (2) screws with a screwdriver and open the lamp cover.

Loosen the two (2) screws with a screwdriver and pull out the lamp assembly by using the built in handle.

APPENDIX

LAMP REPLACEMENT

When the projection lamp of this projector reaches its end

of life, the LAMP REPLACE indicator lights orange. If this

indicator lights orange, replace the projection lamp with aTOP CONTROL new one promptly.

This indicator lights orange when the projection lamp reaches its end of life.

Replace the projection lamp with a new one promptly.

CAUTION

Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with a lamp assembly of the same type.

Do not drop the lamp assembly or touch a glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace lamp assembly.

1

2

3

4 Replace the lamp assembly with a new one and tighten the two (2) screws. Make sure that the lamp assembly is set properly. Put back the lamp cover and tighten the two (2) screws.

5

6 Reset the Lamp replacement counter (refer to”LAMP REPLACE COUNTER” on the next page).

NOTE:

•Do not reset the Lamp replacement counter when the projection lamp is not replaced.

	LAMP COVER
LAMP	HANDLE
ASSEMBLY

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

●	Model No. of your projector	:	LV-7575
●	Replacement Lamp Type No.	:	LV-LP28
			(610 328 7362)

48