„Error No.: 2002 Is Displayed

Cause

Action

PictBridge compliant device is

See “An unsupported USB hub is connected. Remove the hub.” in “An Error

connected via an unsupported USB

Message Is Displayed on the LCD” on page 57.

hub.

 

Error Message Appears on a PictBridge Compliant Device

The following are the possible errors that may occur when printing directly from a PictBridge compliant device and the countermeasures to clear them.

Note

zThis section describes errors that are indicated on Canon-brand PictBridge compliant devices. The error messages and operations may vary depending on the device you are using.

For errors on non-Canon PictBridge compliant devices, check the error message on the LCD and take the appropriate action to clear the error. For details, see “An Error Message Is Displayed on the LCD” on page 57.

zFor the errors indicated on the PictBridge compliant device and their solution, also refer to the instruction manual of the device. For other troubles on the device, contact the manufacturer.

Error Message

Action

On PictBridge

 

Compliant Device

 

“Printer in use”

If the machine is printing from the computer or warming up, wait until the job

 

ends. When it is ready, the machine starts printing automatically.

 

When printing first after changing the media type, the message asking you to

 

confirm the position of the Paper Thickness Lever may appear on the LCD on

 

the machine. If this message is displayed, make sure that the Paper Thickness

 

Lever is set appropriate, then press the OK button on the machine.

“No paper”

Load paper in the Rear Tray, and select Continue* in the display on your

 

PictBridge compliant device.

 

* To resume printing, you can also press the OK button on the machine instead

 

of selecting Continue on the camera.

“Paper jam”

Select Stop in the display on your PictBridge compliant device to stop printing.

 

Remove the jammed paper, load new paper, press the OK button on the

 

machine, and try printing again.

“Printer cover open”

Close the Scanning Unit (Printer Cover) on the machine.

“No print head”

The FINE Cartridge is not installed or the Cartridge may not be compatible with

 

this machine.

 

For details on how to resolve the error, see “The following ink cartridge cannot

 

be recognized. U051/U052/U053/U059” in “An Error Message Is Displayed on

 

the LCD” on page 57.

“Waste tank full”/

The ink absorber is nearly full.

“Ink absorber full”

For details on how to resolve the error, see “The ink absorber is almost full.

 

Press [OK] to continue printing. Contact the service center.” in “An Error

 

Message Is Displayed on the LCD” on page 57.

70Troubleshooting