Manual Flash Mode

After step 3 on the preceding page, following the steps below to set a different flash output between flash tube A and B.

Press the <RATIO> button and

select IimiI!l A : B •

M

~ Each time you press the button, the selection will change in the following loop:

~(OFF)-~1imiI!l A: B I

~IimiI!lA:B:C~

M

fiBiI!) A : B

~.D

The flash output is displayed on the lower right of the LCD panel. When A is displayed, the flash output displayed is for flash tube A.

Press the < <J > or < C> > button to select flash tube A or B, then press the < + > or < - > button to set the flash output.

~First select the flash tube, then set the flash output for that flash tube.

The remaining steps are the same as steps 6 and 7 on the preceding page.

Press the <-> button and set the flash output to --. This disables the selected flash tube from firing.

The -- setting comes after the 1/64 setting. The flash tube whose flash output is set to -- will not fire. Also, you cannot set -- for both flash tubes.

61

Page 61
Image 61
Canon MR-14EXl manual Press the Ratio button, Select IimiI!l a B