Canon MVX20i, MVX25i instruction manual List of Messages, Memory Card Related Messages

List of Messages

Message	Explanation		E
SET THE TIME ZONE,	You have not set the time zone, date and time. This message	19
DATE AND TIME	appears each time you turn the power on until you set the
	time zone, date and time.
CHANGE THE	Battery pack is exhausted. Replace or charge the battery	11
BATTERY PACK	pack.
THE TAPE IS SET FOR	Cassette is protected. Replace the cassette or change the	150
ERASURE PREVENTION	position of the protect switch.
REMOVE THE	Camcorder stopped operating to protect the tape. Unload	14
CASSETTE	and reload the cassette.
CHECK THE DV INPUT	DV cable is not connected, or the connected digital device is	82
	turned off.
CONDENSATION HAS	Condensation has been detected in the camcorder.	147
BEEN DETECTED
TAPE END	Tape reached the end. Rewind the tape or replace the	–
	cassette.
CHECK THE CASSETTE	You attempted to perform audio dubbing on a tape	89
[REC MODE]	recorded in a mode other than the SP mode.
CHECK THE CASSETTE	You attempted to perform audio dubbing on a tape	89
[AUDIO MODE]	recorded in 16-bit or 12-bit 4-channel sound.
CHECK THE CASSETTE	You attempted to perform audio dubbing on a tape with a	89
[BLANK]	blank section.
HEADS DIRTY, USE	Video heads are dirty. Clean the video heads.	147
CLEANING CASSETTE
COPYRIGHT PROTECTED	You attempted to play back a copyright protected tape.	86
PLAYBACK IS RESTRICTED
COPYRIGHT PROTECTED	You attempted to dub a copyright protected tape. May also	86
DUBBING RESTRICTED	appear when an anomalous signal is received during analog
	line-in recording, or during analog-digital conversion of a
	copyright protected tape.

Memory Card Related Messages

Message		Explanation
NO CARD	Memory card not is inserted into the camcorder.			93
THE CARD IS SET FOR	SD Memory Card is set for erasure prevention. Replace the			93
ERASURE PREVENTION	card or change the position of the protect switch.
NO IMAGES	No images are recorded on the memory card.			–
CARD ERROR	A memory card error occurred. The camcorder cannot record			–
	or play back the image.
	The error may be temporary. If the message disappears after
	4 seconds and	flashes red, turn the camcorder off, remove
	the card and reinsert the card. If		changes to green, you
	can continue recording/playback.
CARD FULL	No remaining capacity on the memory card. Replace with			–
	another card or erase images.
NAMING ERROR	File or folder number has reached the maximum value.			96

Information Additional

143