Canton 3C16476CS Port Mirroring, Spanning Tree Detail Screen, Spanning Tree Setup Screen

Models: 3C16476CS

1 79
Download 79 pages 42.53 Kb
Page 49
Image 49
Figure 46 Spanning Tree Detail Screen

Figure 46 Spanning Tree Detail Screen

Setup

Use the Setup tab to configure the spanning tree settings for each port. The following options are available:

Status – Enables and disables spanning tree for the port.

Edged Port – Enables and disables edged port for the port.

Link Type – Choose between Point-to-Point, Shared, or Auto for the link type.

Path Cost – The path cost is used to determine the best path between devices. The path cost method is used to determine the range of values that can be assigned to each interface.

Port Priority – Used in selecting the root device, root port, and designated port. The device with the highest priority becomes the STA root device. However, if all devices have the same priority, the

Configuring Port Settings

49

device with the lowest MAC address will then become the root device.

If you modify any of these settings, click Apply to save your changes.

Figure 47 Spanning Tree Setup Screen

Port Mirroring

The Switch allows you to monitor traffic going in and out of a particular port. For traffic monitoring to work, you need to attach a network analyzer to one port and use it to monitor the traffic of other ports in the stack.

To set up traffic monitoring, you need to set an analysis port (the port that is connected to the analyzer), and a monitor port (the port that is to be monitored). Once the pair is defined, and you enable traffic monitoring, the Switch takes all the traffic going in and out of the monitor port and copies it to the analysis port.

CAUTION: The analyzer port should have a higher bandwidth than the mirror port. Otherwise, the Switch may not be able to copy all traffic effectively during periods of high traffic.

Page 49
Image 49
Canton 3C16476CS manual Port Mirroring, Spanning Tree Detail Screen, Spanning Tree Setup Screen