Channel “A” Button

 

Channel “B” Button

 

The two headsets in your retail box are already factory paired and ready to use. Unless you wish to add additional bikers for a 3-way or 4-way call, you can skip the following explanation and proceed directly to section 9.4

HEADSETS TO BE PAIRED

GO TO

SECTION

 

Your G4 with a third G4 unit

9.10 b

Your G4 with one G4 and one Q2 unit

9.11 c

Your G4 with two Q2 units

9.11 c

Your G4 with one G4 and one other scala rider model

9.11 c

Your G4 with one Q2 and one other scala rider model

9.11 c

Your G4 with two other scala rider models

9.11 c

Your G4 as part of 4-Way intercom call configuration

9.10 c

9.4  INITIATE INTERCOM CALLS

There are two ways to start an Intercom call with headsets that are paired to your scala rider G4 (make sure you are in Standby mode):

Read the following if you want to set up 3-way or 4-way calls and/or if you wish to pair your headset(s) with earlier scala rider models:

Since the scala rider G4 can be paired with all models among the scala rider family, we recommend that you first pair it according to your preferred configuration and then change or modify as often as you wish later as the need arises. For example: If you typically use the intercom to communicate with two friends who both use G4 units, then you should pair it as described below in section 9.10 b.

Therefore, please select your initial pairing preference now amongst the following options in the table below and following that, refer to the pairing procedure as described in the respective section of this manual. When done, return to the explanations in section 9.4 “Initi- ate Intercom Calls”.

VOICE CONNECT:

Preferred for relatively brief conversations as it takes the channel into standby mode after 30 seconds of silence

Start talking loudly

Once you start talking loudly, an Inter- com call will be established with both paired headsets, CHANNEL “A” and CHANNEL “B” (if both are available).

The Intercom call will stay on until all participants remain silent for 30 seconds (Applicable for 2-way communication).

CHANNEL BUTTON CONNECT:

Preferred for extended conversa- tions as it leaves the channel open and active

Single tap the CHANNEL “A” Button to add or remove the CHANNEL “A” headset from an Intercom call.

Single tap the CHANNEL “B” Button to add or remove the CHANNEL “B” headset from an intercom call.

Select your preferred Pairing Option

HEADSETS TO BE PAIRED

GO TO

SECTION

 

Your G4 with another G4

9.10 a

Your G4 with a Q2

9.11 a

Your G4 with one earlier scala rider model

9.11 b

NOTE: While the Intercom is on, the Redial and Voice Dial functions will be disabled.

9.5 RECEIVING INTERCOM CALLS

Once another paired headset tries calling you via intercom, the call will begin almost instantly.

14 scala rider® G4PowerSet

Page 14
Image 14
Cardo G4 manual Initiate Intercom Calls, Select your preferred Pairing Option, Receiving Intercom Calls