English
3. Adjust the Helmet Clamp’s location on the Helmet so that the
microphone is located opposite the center of
your mouth. You may need to reposition the
Clamp repeatedly until you identify the best
spot. (Be sure to clean the selected area prior
to the gluing process).
4. Use the pre-moistened Towlette to clean the helmet area where
you want to install the Glue Plate. Allow to dry thoroughly.
5. Peel the foil cover from the Glue Plates’ adhesive pad.
6. Place the Glue Plate into position according to #3. Press rmly
15 seconds on all 3 parts of the Glue Plate.
7. The adhesive pad bonds to full strength over the next 24
hours. Therefore it is recommended to not use the headset
during this 24 hour period.
8. Fasten the Clamp to the Glue Plate using the Allen screws that
were previously removed.
If you have purchased a helmet clamp version with the corded
microphone, please proceed as follows:
5.2 ATTACHING THE CO RDED MIC ROPHONE CLAMP ON A
FULL-FACED H ELMET
If you are using the corded microphone version, you must rst make
sure your helmet clamp is attached to your
helmet as described in previous section (5.1).
Clean the exact spot on the internal padding of
the helmet, opposite your mouth, where the
microphone will be placed.
a. Peel the foil cover from the adhesive Velcro
pad and place the Velcro pad on the chosen
location opposite your mouth.
b. Attach the microphone to the Velcro, as shown in photo.
c. When done, tighten the screws of the clamp
5.3 POSITIONI NG THE MI CROPHON E AND SPEA KERS
Speaker A
Speaker B
The microphone must be positioned in
front of the center of your mouth as
detailed above.
Attach the speakers to the Velcro inside
your helmet, opposite your ears (short
speaker cord for left ear & long speaker
cord for right ear). Use the supplied
Velcro pads if needed.
Using two spea kers inside the
helmet may be prohibited in
certain jurisd ictions. If this is t he
case, you shou ld tuck away the
long corded sp eaker under neath
the helmet pa dding as fo llows:
Speaker A
Speaker B
Speaker B
Cable
Lead the speake r cord [B]
alongside the rim of the
padding to the right side and
then back to t he left s ide, near
speaker [A]. Then place the
speaker [B] und erneath the
padding.
NOTE: For best audio re sults, make su re that both of your spea kers
actually touch your e ars.
Please visit us at ww w.cardosystems .com/faq and loo k for
some very useful tip s under the A udiokit categor y.
7
scala rider® G4™ PowerSet