Cardo G4 manual Both headsets should now be flashing slowly in Blue, Making 4-Way Intercom calls

NOTE: The scala rider G4 PowerSet package, contains two factory paired G4 headsets. If you did not change the original pairing settings, you can skip “step one” below:

Step One: Pair Driver 1 to Passenger 2 via Channel “A” as follows

a. Turn both headsets ON by pressing and holding the Mobile Buttons until the Blue Light flashes three times.

b. Both headsets should now be flashing slowly in Blue.

c. Press and hold CHANNEL (“A”) BUTTON on both headsets for at least six seconds until the headset’s BLUE or RED Light begins flashing rapidly, indicating that they have entered the Intercom Pairing mode. (See Intercom Channel Table for Pairing Light indication for each CHANNEL)

d. Release the buttons and wait until both headsets display a solid light for two seconds, indicating that the two headsets are now paired for Intercom connections. (This may take up to two minutes)

Step Two: Pair Driver 3 to Passenger 4 via Channel “A”

Repeat the above pairing procedure between Driver 3 and Passenger 4

Step Three: Pair Passenger 2 to Passenger 4 via Channel “B”

Repeat the above pairing procedure between Passenger 2 and Pas- senger 4 using the Channel “B” button. (instead of Channel “A” button as described in bullet c above).

Your 4-Way Conference Intercom Pairing is now complete and ready to use.

NOTE: If the Pairing process is not completed within two minutes the headsets will return to Standby mode.

Making 4-Way Intercom calls

Once you have successfully paired the four headsets as described above, and all units are in standby mode, proceed as follows to start a

4-way Conference Intercom call:

a. Passenger 2 should press Button “B” to initiate a call with Passenger 4. Wait until audio is heard on both headsets and proceed to the next step.

b. Driver 1 should press Button “A” to initiate a call with Passenger 2.

c. Driver 3 should press Button “A” to initiate a call with Passenger 4.

Now the 4-way intercom conference mode is established.

NOTE: If one of the headsets should disconnect or drop off from the 4-way call and fails to reconnect, repeat the three steps above.

9.11USING THE G4 FOR INTERCOM WITH OTHER   SCALA RIDER HEADSETS

INTERCOM	PAIRING / CONNECTION	PAIRING MODE LED
CHANNEL	BUTTON	INDICATORS
CHANNEL “A”	CHANNEL “A” BUTTON	Rapid RED flashing
CHANNEL “B”	CHANNEL “B” BUTTON	Rapid BLUE flashing

18 scala rider® G4™ PowerSet