4.4 FIRMWARE UP GRADE OP TION
In the future you will be able to install rmware
upgrades and program patches to keep the
software of your G4 up-to-date. Among others,
future rmware upgrades will include additional
status announcements and other valuable functions. To ensure that
you don’t miss out on the latest versions, please register online at
www. cardosystems.com/download/softwareupgrade and have
your serial number ready. For downloading upgrades, please use the
USB cable included in the retail package of your scala rider G4.
Please note that until further notice, upgrades will only be available for
Windows™ based computers with XP™ or Vista™ operating systems.
4.5 RESETTI NG YOUR HEA DSET
If your headset fails to respond despite repeated attempts, you can
reset your headset by charging it. After approximately 10 seconds,
remove the headset from the charger and turn it on again. Your head-
set should now respond as expected.
5. GETTING STARTED
5.1 M OUNTING T HE HEADS ET ON THE H ELMET
The Helmet clamp that includes your microphone and speakers must
rst be mounted on the helmet. Once mounted, the headset unit can
be attached or detached from the clamp at any time (sec. 5.4).
There are two methods that can be used to attach the clamp to the
helmet:
Standard Method: Recommended for most helmet types.
Glue Plate Method: Recommended for helmets
to which the standard method cannot be applied,
using the Glue Plate included in the box.
Glue Plate
Standard Method: Fastening the Clamp to the
Helmet
1. Use the enclosed Allen Wrench to loosen
the two screws on the Back Plate.
2. Slide the Back Plate between the internal
padding and the external shell of the helmet.
3. Adjust the clamp’s location so that the
microphone is located in front of the center
of your mouth, and then tighten the screws.
You may need to reposition the Clamp
repeatedly until you identify the best spot.
If you have purchased a helmet clamp version with
the corded microphone, please refer to section 5.2.
Glue Plate Method: Attaching the Clamp by way of glue
You have the option to glue the Helmet Clamp onto your helmet,
when the above standard method cannot be used, or in case you
prefer to secure the Helmet Clamp with adhesive glue.

Caution: This process can be done only once!

NOTE: While we have no reason to believe that the gluing option might nega-
tively aect any helmet, Cardo does not assume any responsibility
to that eect, irrespective of its nature and circumstances. The Glue
Plate is oered as a free option that you may choose to use at your
own risk and subject to renouncement of any future claims.
1. Use the enclosed Allen Wrench to remove
both Allen screws and release the Helmet
Clamp’s back plate.
2. Determine the location on the helmet where the Helmet
Clamp must be attached.
6scala rider® G4™ PowerSet